Pack of two 5V RGB LED modules with resistors for Arduino. Easy 4-pin connection for custom colour lighting in projects.
Whadda UK 2.8-inch capacitive touchscreen display module with 240 x 320 resolution and 262K colours for Arduino Uno and Mega projects.
Whadda UK oscilloscope and logic analyser shield for Raspberry Pi with 1 MS/s sampling and a 10-channel logic analyser.
Interactive Arduino shield for beginners. LEDs, sounder, 7-segment display, sensors. Ideal for STEM lessons.
Add Ethernet to your Arduino Uno with this ENC28J60 shield kit. 10Mb/s speed, stackable design, assembly required.
2‑channel Arduino shield with L298P driver, 2.5A per channel, 50V max input. Stackable, fully assembled.
ATmega32u4 Arduino Leonardo compatible development board by Whadda. Features Micro USB, 20 digital I/O pins & 16MHz clock. Ideal for prototyping.
Whadda UK 16x2 LCD & Keypad Shield for Arduino. Features blue backlit display, single analogue input for directional buttons & reset switch.
Compact 3x4 membrane keypad module for Arduino. Features adhesive backing, 7-pin connection, 90mm cable & uses keypad.h library.
Integrate microcontrollers into Bluetooth networks with the Whadda WPI302 HC-05 Module. Bluetooth v2.0, 2.1Mb/s speed. Ideal for Arduino.
Dual sensor set for Arduino measuring soil moisture & water levels up to 40mm. 5V DC operation by Whadda UK.
Whadda UK WPSE311 module with DHT11 sensor for digital temperature & humidity readings. Ideal for Arduino projects & environmental monitoring.
Pack of 2 Whadda vibration switch modules with 10kΩ pull-up resistor. 5V DC operating voltage, 3-pin header. Ideal for Arduino projects.
Compact SMD RGB LED module for Arduino. Control full colour spectrum with PWM. Pack of 2. Low power, high brightness.
Whadda active buzzer modules for Arduino (2 pack). Operating at 5V DC with a 1.5-2.5kHz frequency. Ideal for sound alerts in electronics projects.
TP4056 USB charging module for 3.7V lithium batteries. 1A adjustable current, LED indicator. Pack of 2. Ideal for DIY and Arduino.
Whadda LM2577 DC-DC step-up module for Arduino. Adjustable 5V-55V output from 3.5V-35V input.
Compact 2x3W stereo amplifier module for Arduino. Low power, USB compatible, drives small speakers. Ideal for audio projects.
Control two DC motors or one stepper motor with this Whadda UK L298N Arduino controller board. 25W max power, 5V-35V supply.
40-way male to male jumper wire, 300mm, pre-cut and pre-stripped. Copper conductors, PVC insulation, for breadboard prototyping.
40-way male to female jumper wires, 300mm. Ideal for breadboard prototyping with copper conductors and PVC insulation.
Whadda ATmega328P microcontroller IC with Arduino Uno bootloader and 16 MHz crystal oscillator. 32 KB flash, 2 KB SRAM and 23 I/O lines.
Add up to 32GB storage to your Arduino with this MicroSD logging shield. SPI interface, 4.5-5V, pack of 2. Ideal for data logging.
Whadda UK ultrasonic sensor for Arduino with 5.5m range. Ideal for robotics, obstacle avoidance & distance measurement in DIY projects.
